Set the wrong BAUD rate

[ittechk4u1]

By mistake I set the BAUD rate to 230400 via rommon mode of Cisco 2960 Switch.

Now i don't have access via console as well via this BAUD rate. I also tried with 115200 but showing the unreadable char.

Can anyone tell me the to reset the BAUD to 115200 or 9600!!!!

Thanks

[Mark Malone]

Try this below from this post

https://supportforums.cisco.com/discussion/10538086/unable-change-console-speed-c2960-setunset-baud

This is what I did:

-shutdown the switch

-press Mode button while power on the switch to enter in switch: mode.

-enter set command to see the BAUD=115200

-enter flash_init command

-now is the right moment to enter unset BAUD command

-continue booting the switch in my case with

boot flash:c2960-lanbase-mz.122-2-25.SEE3.bin

[ittechk4u1]

I did that

and now cant see anything on console..all are diff chars....."{ъыъъэщщыщ"

even after booting... just showing these..[аАФю     юююююю      юю  юю    юююю        юю

Thanks

[ittechk4u1]

after reboot console setting will be change or it keep the old one!!!?