My Company bought a SG 300-52 Gigabit Managed Switch. The switch does not support POE.
Software version is 1.1.1.8
Boot version is 1.1.06
HW is v02
I am wondering how do i make this switch interface to layer 3 because it does not take commands like (no switchport) (ip routing)
I can create vlans using the old way ie (vlan database)
Using other switches which runs cisco ios 12.1 and up i have no problem in creating SVI and routed interfaces.
I am not so sure whether this type of switch can do this. Any suggestions on how to go about it are welcome
Thank you guys in advance!!!
Paul M
