cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1366
Views
0
Helpful
5
Replies

SG112-24 Ports

JimHanus35104
Level 1
Level 1

I'm totally new to networking. I've just replaced a D-Link switch with a Cisco SG112-24 unmanaged switch, and I can't find detailed instructions for it. Specs say ports are 22 x 10/100/1000 + 2 x combo SFP. This switch is just used for basic networking ( PC's, some printers and a router). Should the router be plugged into the combo SFP port, or does it matter which of the 22 ports the router in plugged into? Any info is greatly appreciated!

1 Accepted Solution

Accepted Solutions

OK, I will try it. Thanks.

View solution in original post

5 Replies 5

balaji.bandi
Hall of Fame
Hall of Fame

JimHanus35104
Level 1
Level 1

My port layout is different than the diagram shown on page 12. I'm assuming the world logo means internet?

yes for uplink.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

OK, I will try it. Thanks.

Does the SFP port require an adapter to use an RJ45? The only contacts are deep inside the port on my switch. My switch does not have 2 sets of ports at the right end as shown in the Unmanaged Switches Guide you sent, just the 2 SFP ports.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: