cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
472
Views
0
Helpful
3
Replies
Highlighted
Beginner

SG350X SFP+ Port Duplex mismatch

Hi,

 

I have a SG350X which is connected to a Mellanox 6036 in Ethernet mode via a 4:1 splitting cable.

The Port on the Cisco is complaining about a Duplex mismatch every 5 minutes.

 

Since this is a 10G Port, no manual duplex configuration can be performed.

 

The Mellanox setup is correct, it has been in place since before the Cisco was brought in.

I am investigating a strange (temporarily occurring) STP issue that recently began, thats why I noticed this  issue in the first place.

 

Any idea why that would be/how to resolve it?

 

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

Ok,

after ignoring this for a couple of month i looked at it again.

I found this: https://community.cisco.com/t5/routing/cdp-sw1-4-duplex-mismatch/td-p/3021049

 

So i disabled CDP as suggested and the problem is gone...

 

View solution in original post

3 REPLIES 3
Highlighted
Beginner

So nobody never had that issue, heard of it, solved it?

Highlighted

Still getting

"DUPLEX_MISMATCH - Duplex mismatch detected on interface te1/0/3." every 5 minutes :/

Highlighted

Ok,

after ignoring this for a couple of month i looked at it again.

I found this: https://community.cisco.com/t5/routing/cdp-sw1-4-duplex-mismatch/td-p/3021049

 

So i disabled CDP as suggested and the problem is gone...

 

View solution in original post

Content for Community-Ad
This widget could not be displayed.