When I run sh port-channel traffic command, I get the following. Most of these port channels are setup for ESX vm hosts, and I don't know what does it mean when it shows 100%.
Is the interface associated with the port channel 100 utilized?
If I do a show interface e1/17, it doesn't show it maxed out, in fact it is < 1 mbps.
ChanId Port Rx-Ucst Tx-Ucst Rx-Mcst Tx-Mcst Rx-Bcst Tx-Bcst
------ --------- ------- ------- ------- ------- ------- -------
1 Eth1/31 52.96% 37.24% 38.20% 40.43% 18.11% 82.18%
1 Eth1/32 47.03% 62.75% 61.79% 59.56% 81.88% 17.81%
------ --------- ------- ------- ------- ------- ------- -------
10 Eth1/1 45.54% 30.48% 52.07% 63.67% 52.78% 32.59%
10 Eth1/2 54.45% 69.51% 47.92% 36.32% 47.21% 67.40%
------ --------- ------- ------- ------- ------- ------- -------
114 Eth1/17 100.00% 100.00% 100.00% 100.00% 100.00% 100.00%
------ --------- ------- ------- ------- ------- ------- -------
115 Eth1/18 100.00% 100.00% 100.00% 100.00% 100.00% 100.00%
------ --------- ------- ------- ------- ------- ------- -------
116 Eth1/19 100.00% 100.00% 100.00% 100.00% 100.00% 100.00%
------ --------- ------- ------- ------- ------- ------- -------
117 Eth1/20 100.00% 100.00% 100.00% 100.00% 100.00% 100.00%
------ --------- ------- ------- ------- ------- ------- -------
118 Eth1/21 100.00% 100.00% 100.00% 100.00% 100.00% 100.00%
------ --------- ------- ------- ------- ------- ------- -------
119 Eth101/1/6 100.00% 100.00% 100.00% 100.00% 100.00% 100.00%