cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3064
Views
0
Helpful
3
Replies
Highlighted
Participant

Show Exact Temperature Value on 2960-G

Hi Guys,

 

Is it possible to show the exact temperature value on 2960-G? When I issued command "show env temperature", the switch only displayed information below:

SW2960G#sh env temperature
TEMPERATURE is OK

 

But on my other switch, when I issued the same command, the switch returned a more detailed information like below:

SW3850#sh environment temperature
Switch 1: SYSTEM TEMPERATURE is OK
Inlet Temperature Value: 29 Degree Celsius
Temperature State: GREEN
Yellow Threshold : 46 Degree Celsius
Red Threshold : 56 Degree Celsius

 

Is it the 2960-G's IOS limitation?

 

Thank you.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Community Legend

Nope. Not possible.

View solution in original post

3 REPLIES 3
Highlighted
Hall of Fame Community Legend

Nope. Not possible.

View solution in original post

Highlighted

Ah, I see. But is it possible for SNMP to catch the trap for temperature? I've seen monitoring system like OpManager and Solarwinds able to capture the device's SNMP. Is it possible to capture the temperature via the monitoring system? Or still not? Hehehe.

 

Thanks.

Highlighted
Hall of Fame Community Legend

Cisco Catalyst 2K/3K switch don't support temperature readings. It's only green/yellow/red. That's it.
Content for Community-Ad