cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5736
Views
12
Helpful
6
Replies

show interfaces f0/1 counters doesnt work

bade11
Level 1
Level 1

I gave the IP adresses PC0 and PC1. And I would like run this command show interfaces f0/1 counters and doesnt work. 

scr.PNG

6 Replies 6

Jaderson Pessoa
VIP Alumni
VIP Alumni
No, its doesn`t work on packet tracert. Some features dont works well on packet tracer. Otherwise, you can use other features, like EVE-NG, GNS3 or VIRL.

EVE-NG: https://www.eve-ng.net/downloads
GNS3: https://www.gns3.com/
VIRL: https://dcloud.cisco.com/

Best regards

Rate all post that were help you.
Jaderson Pessoa
*** Rate All Helpful Responses ***

luis_cordova
VIP Alumni
VIP Alumni

Hi @bade11 ,

 

In PacketTracer, to see the settings in an interface you can use these commands:

#show running-config

#show ip interface brief

#show ip interface gigabitEthernet 0/0

#show interfaces gigabitEthernet 0/0

#show interfaces gigabitEthernet 0/0 status 

 

Regards

#show ip interface gigabitEthernet 0/0 doesnt work others are work. 
show interfaces f0/1 counters still doesnt work.

sc3.PNG

As i said before, some feature doesn't working properly at PACKET TRACER, i suggest you to alternate for GNS3, EVE-NG or VIRL.

 

No, its doesn`t work on packet tracert. Some features dont works well on packet tracer. Otherwise, you can use other features, like EVE-NG, GNS3 or VIRL.

EVE-NG: https://www.eve-ng.net/downloads
GNS3: https://www.gns3.com/
VIRL: https://dcloud.cisco.com/

Best regards

Rate all post that were help you.

Jaderson Pessoa
*** Rate All Helpful Responses ***

Hi @bade11 ,

 

The command #show ip interface gigabitEthernet 0/0 shows the layer 3 parameters of the interface.

That's why, in a layer 2 switch, it does not work.

If you test it on a router, you will see that it works.

The PacketTracer program is an emulation of the real devices, so the IOS in them do not have all the commands of a real IOS.

For a more realistic environment, you can use the programs that correctly mention by @Jaderson Pessoa .

 

Regards

Deepak Kumar
VIP Alumni
VIP Alumni

Hi,

You are working on PT and it is having limited commands on switch/routing/firewall platforms. You can go with GNS/VIRL but if possible go with Real network devices. You can buy old devices from eBay or ask for any old IT company. 

 

Regards,

Deepak Kumar

 

Regards,
Deepak Kumar,
Don't forget to vote and accept the solution if this comment will help you!
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card