cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
790
Views
0
Helpful
4
Replies

show port channel on cat 95k

nflnetwork
Level 1
Level 1

hi there i have configured a port channel with 4 total ports. 

 

is there a command i can run that will show the aggregate bandwidth?

 

ie. 4 x 10 GB ports - 40 GB total throughput ?

 

 

how can i see this ?

 

thanks,

1 Accepted Solution

Accepted Solutions

Reza Sharifi
Hall of Fame
Hall of Fame

Try,

sh int poxx

You should see something like this

MTU 1500 bytes, BW 40000000 Kbit/sec, DLY 10 usec

 

HTH

View solution in original post

4 Replies 4

Hello


@nflnetwork wrote:

hi there i have configured a port channel with 4 total ports. 

 

is there a command i can run that will show the aggregate bandwidth?

 

ie. 4 x 10 GB ports - 40 GB total throughput ?

 

 

how can i see this ?

 

thanks,


show port-channel summary

 


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

this command does nto exist

9500-A#sh port ?
address Show secure address
interface Show secure interface
| Output modifiers
<cr> <cr>

9500-A#sh port

Reza Sharifi
Hall of Fame
Hall of Fame

Try,

sh int poxx

You should see something like this

MTU 1500 bytes, BW 40000000 Kbit/sec, DLY 10 usec

 

HTH

this works

Port-channel5 is up, line protocol is up (connected)
Hardware is EtherChannel, address is 9077.ee5b.aa0e (bia 9077.ee5b.aa0e)
Description: Port-Channel to Cisco-9200 Access
MTU 9216 bytes, BW 40000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 10Gb/s, link type is auto, media type is N/A
input flow-control is on, output flow-control is unsupported
Members in this channel: Twe1/0/46 Twe1/0/47 Twe2/0/46 Twe2/0/47
ARP type: ARPA, ARP Timeout 04:00:00
Last input 14:56:57, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 2836000 bits/sec, 678 packets/sec
5 minute output rate 2972000 bits/sec, 553 packets/sec
4447747 packets input, 1818085731 bytes, 0 no buffer
Received 113067 broadcasts (68275 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 68275 multicast, 0 pause input
0 input packets with dribble condition detected
6131958 packets output, 4513507241 bytes, 0 underruns
Output 81275 broadcasts (0 multicasts)
0 output errors, 0 collisions, 2 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
Review Cisco Networking products for a $25 gift card