Create a simple network as shown in the figure.
Need config for IR829 and Catalyst 3560 (be specific to these devices), so that a PC as end user be able to ping to the router.
Go to Solution.
it uses SVI interface Vlans as Layer 3 interfaces
swithcport mode access
switchport access vlan 10
desc to switch fas0/1
switchport mode access
swithcport access vlan 20
int vlan 10
ip address 192.168.10.1 255.255.255.0
int vlan 20
ip address 192.168.20.1 255.255.255.0
! above to make SVI Vlan20 to stay up even if gi2 is not connected
Note: the switchport command may be not needed or even not accepted on IR829 in case go on to put the following commands.
b) SW 3560
desc to IR829:gi1
desc to PC
ip address 192.168.10.250 255.255.255.0 DEF GW 192.168.10.1
remember to save configurations on router and switch with
copy running-config startup-config
Hope to help
View solution in original post
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: