So im doing an event where im getting a p2p shot for my internet. And at our main office is not exactly that close to the link we have a fiber running connecting to a switch near by that is bringing the internet back on a vlan. Now we also have a point to point shot coming from the same switch incase something happens to our cable connecting the ISP point to point to the switch. My goal was to connect the two switches both the fiber link and the p2p link. But whenever I connect them both. It will send all the traffic over the point to point link and not the wired link. I am having a hard time getting the switches to use the wired link inside of the p2p..
increase the spanning-tree cost on the wireless point to point interfaces by using
spanning-tree cost 10000
in interface configuration mode on both switches
in this way the fiber link should be preferred
Hope to help
Giuseppe
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
