SNMP Graph ( PRTG ) Subinterface traffic not proper after replace ASR1002 from Cisco 7206

[dc-csa-blr]

Dear Team,

We're facing SNMP Graph after replace ASR1002 instead of Cisco 7206.

SNMP Graph issue only connected via subinterface users ( it is like zigzag) graph Issue  only on subinterface traffic after replace ASR1002.

When we were using Cisco 7206 that time no any SNMP graph issue on subinterface traffic.

There is no any issue snmp graph on conneceted interface it is showing perfact on ASR1002

How to resolve ( subinterace snmp graph in zigzag ).

PFA - SNMP Graph for your reference and also see the below configuration of parent / subinterface.

interface GigabitEthernet0/0/1
 description *** Connect to Cisco 3750 ***
 no ip address
 ip route-cache policy
 load-interval 30
 negotiation auto

interface GigabitEthernet0/0/1.7
 description *** users ***
 bandwidth 4096
 encapsulation dot1Q 7
 ip address 10.10.10.1 255.255.255.240
 service-policy input 4mb
 service-policy output 4mb

Thanks in ADV,

[kaizume2010]

I had this problem with Nexus 3064 switch  too 

[marce1000]

 - Make sure the queried snmp-oid-interface parameters are correct in PRTG for the new device, you may want to snmpwalk the interface-oids and verify this.

 M.