cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1171
Views
0
Helpful
1
Replies

SNMP MIBs for Monitor Modules at Cisco CAT 4500 Series

mbroger
Level 1
Level 1

Hi Guys

I am trying to monitor the modules of the 4500 Series. The Fan Tray and the Power supplies are no problem for me. This works fine.

At the 6500 Series the module monitoring works also fine with the following MIB OID

1.3.6.1.4.1.9.5.1.3.1.1.10 Instance x for the right Module.

So i get an alarm via Whatsup V12.4 wenn one Module gets down ore is pulled out from someone else than the network admins.

But for the 4500 Series i didnt find in the Cisco MIBs Search the right OID.

Is this not supported on the 4500 Series?

Does anybody have got the right OID for me?

We have got the Ios version Version 12.2(46)SG or 12.2(31)SGA1 on the 4500 Series.

Thx Feichti

1 Reply 1

sslittle
Level 1
Level 1

Hi,

did you manage to monitor the 4500 module status. I am trying the same and the only method appears to receive a trap b ut we prefer to poll the SNMP OID as this is more reliable. Any help appreciated.

Stuart

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: