11-20-2012 04:18 AM - edited 03-07-2019 10:08 AM
Hi,
In Cisco 4500 series sh platform hardware acl input entries stat output, what EndOfCamPermitAll means? Is it for TCAM or CAM?
16368 EndOfCamPermitAll Y 8972549270 EndOfCam
16383 EndOfCamError Y 0 EndOfCam
Regards,
Shahab
11-20-2012 10:51 AM
Hi Shahab,
When you configure per-VLAN capture mode, you should examine the show commands for individual features to verify the appropriate behavior. In per-VLAN capture mode, the invalidated static CAM entries will appear as inactive in the output of the show platform hardware acl input entries static command.
This EndOfCamPermitAll indicates the CAM table only
Refer:
Regards,
Aru
*** Please rate if the post is useful ***
11-21-2012 08:11 AM
Hi Aru,
So does it means that if there is frequent increase in EndOfCamPermitAll entries, it means that the CAM is full & switch is sending the broadcast.
Regards,
Shahab
11-22-2012 02:27 AM
Hi Shahab,
Yes, The CAM table is getting full due to some kind of broadcast.
Regards,
Aru
*** Please rate if the post is useful ***
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide