Some information needed for Cisco 4500

[Shahab Khan]

Hi,

In Cisco 4500 series sh platform hardware acl input entries stat output, what EndOfCamPermitAll means? Is it for TCAM or CAM?

16368 EndOfCamPermitAll                Y        8972549270 EndOfCam

16383 EndOfCamError                    Y                 0 EndOfCam

Regards,

Shahab

[Arumugam Muthaiah]

Hi Shahab,

When you configure per-VLAN capture mode, you should examine the show commands for individual features to verify the appropriate behavior. In per-VLAN capture mode, the invalidated static CAM entries will appear as inactive in the output of the show platform hardware acl input entries static command.

This EndOfCamPermitAll indicates the CAM table only

Refer:

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/15.02SG/configuration/guide/secure.html

Regards,

Aru

*** Please rate if the post is useful ***

[Shahab Khan]

Hi Aru,

So does it means that if there is frequent increase in EndOfCamPermitAll entries, it means that the CAM is full & switch is sending the broadcast.

Regards,

Shahab

[Arumugam Muthaiah]

Hi Shahab,

Yes, The CAM table is getting full due to some kind of broadcast.

Regards,

Aru

*** Please rate if the post is useful ***