12-09-2021 01:56 AM
i have a problem.
i have configured spanning tree on my 2 L3 switches but i don't see the interface per vlan . i only see one interface instead of seeing all the interfaces connected to the switch. There is a photo attached to explain better
Thanks
12-09-2021 02:07 AM
post below output : (not screenshot attachments)
show spanning-tree active
show spanning-tree detail
show spanning-tree brief
show spanning-tree summary
12-09-2021 02:13 AM
12-09-2021 02:15 AM - edited 12-09-2021 02:21 AM
Thank you for the output -
i only see one interface instead of seeing all the interfaces connected to the switch.
what you mean by this, end device connected to switch port ?
12-09-2021 03:14 AM
You will only see the ports in spanning tree output if the ports are up.
Jon
12-09-2021 10:51 AM
can we see topology ?
12-09-2021 01:39 PM
Hello
Just like to add there would be only 1 stp instance per port channel, is this what you mean?
12-09-2021 01:48 PM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: