cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
224
Views
0
Helpful
4
Replies

split port 4 ways error

robertkwild
Participant
Participant

hi all,

trying to split a qsfp port 4 ways but i get the following error

module-type qsfp-split-4 force
% bad split mode, please select 'qsfp-split-2'

thanks,

rob

4 Replies 4

marce1000
VIP Mentor VIP Mentor
VIP Mentor

 

      - On which hardware model   , and software version are you getting this error ?

 M.

its a mellanox switch but uses the same syntax as cisco

 

 - Yet  , not a cisco device  problem, consider contacting mellanox support or search for user forum with searching powers of the Net.

 M.

I used another interface and that let me split it 4 ways

I noticed when I did a "sh int status" it was just even interfaces it was showing, so looks like for every split it uses up 2 interfaces, so the next one, I will miss the next int and slot it in the 2nd one and it works, bit wierd

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers