07-01-2022 07:52 AM
Hello Folks,
Well, I staked 2 9300 switches then I turned on the switches, but when I connected to the switch with a console cable my terminal covered with these interface link state messages, it keeps popping up. Then I decided to remove the stacking cable but these messages stile keeping popping up. Then I did erase start up and /all nvram and these messages keeps popping up, I went to the back of the switch to reset it, also these messages keeps popping up. What should I do???
Both switches are in the same version.
07-01-2022 08:00 AM - edited 07-01-2022 08:01 AM
what is the version of code running both, you need to follow some steps to make the stack working.
1. make sure you have uniq switch number
2. different priority.
follow below guide:
Note : your screenshot not indicated what is the problem, it is hard to ready ( post console total output in text file to read correctly)
07-01-2022 08:03 AM - edited 07-01-2022 08:10 AM
OK But Why these messages keeps popping up ? I can't run any commands.
07-01-2022 08:43 AM
break the stack and read the document and start over again bulding the stack
Note : as i mentioned the pictures not give any information other than how you connected, post the boot logs and configuration to help better.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: