cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
96
Views
0
Helpful
2
Replies
Highlighted
Beginner

standby brief doesn't show active and standby ipv6 for vlan 788

How can i check the active vrrp for vlan788? sh standby brief doesn't show 2403:7000:A000::2/64 is v and 2403:7000:A000::1/64 as standby

Any other commands to show ipv6 standby &  active?

 

interface Vlan788
standby version 2
standby 81 ipv6 2400:7000:A000::1/64
standby 81 timers 1 4
standby 81 preempt delay minimum 60
standby 82 ipv6 FE80::4
standby 82 ipv6 2400:7000:A000::2/64
standby 82 timers 1 4
standby 82 priority 120
standby 82 preempt delay minimum 60
ipv6 address 2400:7000:A000::3/64
no ipv6 redirects
ipv6 ospf 1 area 0
end

Everyone's tags (1)
2 REPLIES 2
Rising star

Re: standby brief doesn't show active and standby ipv6 for vlan 788

Cisco specifies thes commands to verify ipv6 HSRP operation

Step 9 show standby [type number [group]] [all | brief]
Example:
Device# show standby

Displays HSRP information.

 
Step 10 show ipv6 interface [brief] [interface-type interface-number] [prefix]
Example:
Device# show ipv6 interface GigabitEthernet 0/0/0

Displays the usability status of interfaces configured for IPv6.

 

 

show standby (without brief) contains this information:

     Active router is local

     Standby router is FE80::20F:8FFF:FE37:3B70, priority 100 (expires in 7.856 sec)

 

VIP Advisor

Re: standby brief doesn't show active and standby ipv6 for vlan 788

Hello

 


@getaway51 wrote:

How can i check the active vrrp for vlan788? sh standby brief doesn't show 2403:7000:A000::2/64 is v and 2403:7000:A000::1/64 as standby

Any other commands to show ipv6 standby &  active?

 

interface Vlan788
standby version 2
standby 81 ipv6 2400:7000:A000::1/64
standby 81 timers 1 4
standby 81 preempt delay minimum 60
standby 82 ipv6 FE80::4
standby 82 ipv6 2400:7000:A000::2/64
standby 82 timers 1 4
standby 82 priority 120
standby 82 preempt delay minimum 60
ipv6 address 2400:7000:A000::3/64
no ipv6 redirects
ipv6 ospf 1 area 0
end


You dont have vrrp enabled you have hrsp and the commands to view it would be:

show standby
show standby brief






kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards