standby brief doesn't show active and standby ipv6 for vlan 788

[getaway51]

How can i check the active vrrp for vlan788? sh standby brief doesn't show 2403:7000:A000::2/64 is v and 2403:7000:A000::1/64 as standby

Any other commands to show ipv6 standby &  active?

interface Vlan788
standby version 2
standby 81 ipv6 2400:7000:A000::1/64
standby 81 timers 1 4
standby 81 preempt delay minimum 60
standby 82 ipv6 FE80::4
standby 82 ipv6 2400:7000:A000::2/64
standby 82 timers 1 4
standby 82 priority 120
standby 82 preempt delay minimum 60
ipv6 address 2400:7000:A000::3/64
no ipv6 redirects
ipv6 ospf 1 area 0
end

[pieterh]

Cisco specifies thes commands to verify ipv6 HSRP operation

Step 9	show standby [type number [group]] [all | brief] Example: Device# show standby	Displays HSRP information.
Step 10	show ipv6 interface [brief] [interface-type interface-number] [prefix] Example: Device# show ipv6 interface GigabitEthernet 0/0/0	Displays the usability status of interfaces configured for IPv6.

show standby (without brief) contains this information:

     Active router is local

     Standby router is FE80::20F:8FFF:FE37:3B70, priority 100 (expires in 7.856 sec)

[paul driver]

Hello

---

@getaway51 wrote:

How can i check the active vrrp for vlan788? sh standby brief doesn't show 2403:7000:A000::2/64 is v and 2403:7000:A000::1/64 as standby

Any other commands to show ipv6 standby &  active?

interface Vlan788
standby version 2
standby 81 ipv6 2400:7000:A000::1/64
standby 81 timers 1 4
standby 81 preempt delay minimum 60
standby 82 ipv6 FE80::4
standby 82 ipv6 2400:7000:A000::2/64
standby 82 timers 1 4
standby 82 priority 120
standby 82 preempt delay minimum 60
ipv6 address 2400:7000:A000::3/64
no ipv6 redirects
ipv6 ospf 1 area 0
end

---

You dont have vrrp enabled you have hrsp and the commands to view it would be:

show standby
show standby brief