07-29-2012 10:13 PM - edited 03-07-2019 08:02 AM
Hi,
I have configured my switch port gi0/1 with following config but when I run stp command it shows me port type p2p instead of p2p Edge
Goble commands
spanning-tree mode pvst
spanning-tree extend system-id
interface GigabitEthernet0/1
switchport access vlan 5
switchport mode access
spanning-tree portfast
interface GigabitEthernet0/8
switchport access vlan 5
spanning-tree portfast
Interface Role Sts Cost Prio.Nbr Type
------------------- ---- --- --------- -------- ------------------------
Gi0/1 Desg FWD 5 128.1 P2p
Gi0/8 Desg FWD 5 128.8 P2p Edge
Please Help me what is wrong with it.
Thanks
Nomi
07-29-2012 10:30 PM
Hello Nouman,
Configuration looks good, can you take the configuration out and place it one more time to see if it makes a difference.
The switch should place the type as P2P Edge as soon as you enter the Spanning-tree porfast command
Also what happens if you add the spanning-tree porftast default on global configuration mode.
Regards,
07-29-2012 11:04 PM
This has been covered before. Please take a look at https://supportforums.cisco.com/thread/2155657
On top of that you have statically configured the port in access mode and the other is in dynamic disarable mode. it shouldn't make any difference but I just thought to point that out.
HTH,
Fabio
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: