Please help me with the procedure for Soft SUP Failover testing:
sw1#show redundancy
Redundant System Information :
------------------------------
Available system uptime = 7 weeks, 3 days, 13 hours, 20 minutes
Switchovers system experienced = 4
Standby failures = 0
Last switchover reason = user forced
Hardware Mode = Duplex
Configured Redundancy Mode = Stateful Switchover
Operating Redundancy Mode = Stateful Switchover
Maintenance Mode = Disabled
Communications = Up
Current Processor Information :
-------------------------------
Active Location = slot 1
Current Software state = ACTIVE
Uptime in current state = 1 week, 5 days, 14 hours, 24 minutes
Image Version = Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-ENTSERVICESK9-M), Version 12.2(53)SG2, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2010 by Cisco Systems, Inc.
Compiled Mon 15-Mar-10 23:32 by prod_rel_team
BOOT = bootflash:cat4500-entservicesk9-mz.122-53.SG2.bin,1;device:cat4500-entservicesk9-mz.122-53.SG2.bin,1;
Configuration register = 0x2102
Peer Processor Information :
----------------------------
Standby Location = slot 2
Current Software state = STANDBY HOT
Uptime in current state = 1 week, 5 days, 14 hours, 20 minutes
Image Version = Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-ENTSERVICESK9-M), Version 12.2(53)SG2, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2010 by Cisco Systems, Inc.
Compiled Mon 15-Mar-10 23:32 by
BOOT = bootflash:cat4500-entservicesk9-mz.122-53.SG2.bin,1;device:cat4500-entservicesk9-mz.122-53.SG2.bin,1;
Configuration register = 0x2102
sw1(config)#redundancy ?
<cr>
sw1(config)#
