we're implementing MQC on Cat4500 SUP7L-E with service policy input and output (marking, classification, traffic shaping with BW limitation) on Gigabit ports towards users.
On the switch ports the service-policy output is working fine limiting the traffic BW correctly for the class DATA and the other, but the service-policy input is not working since it does not limit the traffic BW...below is a generic sample of config implemented.
Am I missing something sicne it should be supported on this platform both in input and output?
police 30m conform-action transmit exceed-action drop
interface g X/Y
service-policy input POLICY-TRAFFIC-IN
If I check the ACL DATA_IN for the service-policy input I don't see traffic matching...but if i check the ACL DATA_OUT (which is configured as opposite) I see traffic that has matched and it works limiting the bandwidth for DATA to 30m...this is not happening for the input
“Use Serviceability Features to Troubleshoot your Cat9K as a Cisco TAC Engineer”
This special event is open only to Cisco Customers and Partners.
Many pages in the Cisco Community are accessible only to Cisco customers, partners, or logged in ...
Cisco Champion Radio · S7|E40 From SD-WAN to SASE: Speed Up and Secure SaaS Internet Apps
The changing global environment has transformed how enterprise users connect to applications. The SASE architecture delivers important networking and securit...
Hi guys,Have a question regarding spanning tree and way its supposed to work when there is a redundant path in fiber daisy-chained switches. Root switch for all vlans is connected via fiber link to the first of the daisy-chained switches. Below is same co...
Hi Experts, I am designing a Ring topology to connect all all DRs and back to CR sites. Do I need to consider what is the maximum DRs which I am able to connect in the Ring and I am thinking does the latency will be affected if more sites will j...
HiI have an issue with a pppoe command in a subinterface. I'm using a c1841-advipservicesk9-mz.124-25f.bin IOSand I have a problem with the command pppoe-client dial-pool-number6. I can configure in a interface but I can't in a subinterface. Any...