cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

504
Views
0
Helpful
3
Replies
Highlighted
Beginner

Supervisor V-10GE 10Gig Ports

Is it possible to have all four 10gig ports 'active' when I have dual Sup-V10GE's in a Cat4510R-E chassis?  I am under the impression from my research thus far, that it is not possible.

Many Thanks

Dominic

Everyone's tags (3)
3 REPLIES 3
Cisco Employee

Supervisor V-10GE 10Gig Ports

Hello Dominic,

As per the design, Dual uplinks are supported in the following modes of operation:

1) If there are two sups in the device, you can have the first TenGig of each sup active and acting as an uplink.

or

2) If there is a single sup in the chassis, then two interfaces on the same sup would be active and acting as an uplink.

You cannot have dual uplinks on a single sup active when dual sups are installed in the system.

Thanks,

Ricky Micky

*Pls rate useful posts

Beginner

Supervisor V-10GE 10Gig Ports

I agree with Ricky.  I have SUP6-E's in my 4510R-E and able to use all the interfaces but had to oversubscribe to do it.  Your only option is upgrade.  If you haven't read the data sheet on the SUPV, i provided a URL.

http://www.cisco.com/en/US/prod/collateral/modules/ps2797/ps6033/product_data_sheet0900aecd801c5c66.html

Jonathan,

Beginner

Supervisor V-10GE 10Gig Ports

Thanks guys, much appreciated.  Very useful info.

CreatePlease to create content
Content for Community-Ad