08-22-2011 09:25 AM - edited 03-07-2019 01:49 AM
Is it possible to have all four 10gig ports 'active' when I have dual Sup-V10GE's in a Cat4510R-E chassis? I am under the impression from my research thus far, that it is not possible.
Many Thanks
Dominic
08-22-2011 09:37 AM
Hello Dominic,
As per the design, Dual uplinks are supported in the following modes of operation:
1) If there are two sups in the device, you can have the first TenGig of each sup active and acting as an uplink.
or
2) If there is a single sup in the chassis, then two interfaces on the same sup would be active and acting as an uplink.
You cannot have dual uplinks on a single sup active when dual sups are installed in the system.
Thanks,
Ricky Micky
*Pls rate useful posts
08-22-2011 10:46 AM
I agree with Ricky. I have SUP6-E's in my 4510R-E and able to use all the interfaces but had to oversubscribe to do it. Your only option is upgrade. If you haven't read the data sheet on the SUPV, i provided a URL.
Jonathan,
08-25-2011 04:47 AM
Thanks guys, much appreciated. Very useful info.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide