11-28-2011 09:46 PM - edited 03-07-2019 03:38 AM
Dear Friendz,
Connectivity: Telecom Equipment(TE)----RouterA----RouterB.
Pinging from RouA to TE worksbut trace route fails stating "% Subnet not in table".
IP address of TE in defined in OSPF table of RouterA.
Which all points to be checked? Please help...
Solved! Go to Solution.
11-28-2011 11:37 PM
Is the route in the routeing table?
Amd do you see the route when using this command:
show ip ospf database
11-28-2011 11:37 PM
Is the route in the routeing table?
Amd do you see the route when using this command:
show ip ospf database
11-28-2011 11:50 PM
Hi Sharone,
Is the neighborship established between TE and RouterA?
Can you make sure the TE network specified under OSPF?
Please rate the helpfull posts.
Regards,
Naidu.
11-29-2011 12:37 AM
Hi,
Pinging from RouA to TE worksbut trace route fails stating "% Subnet not in table".
How can a ping work if the subnet you are trying to reach is not in the routing table ?
Are you tracerouting to a remote subnet beyond TE ?
Regards.
Alain
11-29-2011 10:00 AM
Thank you friends,
Earlier i checked in the sh run and the IP was there under
router ospf 1
log-adjacency-changes
But in show ip ospf database the IP is not there..
@Alain: Ping worked.. because there is a default route there and it took another path, that i havnt mentioned earlier and sorry for confusing..
Thanks all for the help.
11-30-2011 03:12 AM
Problem not yet solved !
in show ip ospf database the IP is not there..
But IP Route is Created and re-distribution done,
router ospf 1
log-adjacency-changes
redistribute static subnets route-map RNC
Still its not working, please help...
11-30-2011 03:27 AM
Hi,
post your config along with sh ip ospf database and sh ip route.
Regards.
Alain
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: