cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 
cancel
1908
Views
0
Helpful
1
Replies

Switch 2 does not have sufficient power budget after upgarde

Paul Freiberg
Level 1
Level 1

Hallo Community,

we upgarded a stack of two 3750X-48T-S from 122-53.SE2 to 15.0(2)SE5. Now we got every minute this error:


Dec 16 10:39:21: %PLATFORM_STACKPOWER-4-UNDER_BUDGET: Switch 2 does not have sufficient power budget

We restartet the  stack, we unpluged the power cable one by one and changed stack-power mode from Power sharing to Power sharing strict without success.

Power Stack           Stack   Stack    Total   Rsvd    Alloc   Unused  Num  Num

Name                  Mode    Topolgy  Pwr(W)  Pwr(W)  Pwr(W)  Pwr(W)  SW   PS

--------------------  ------  -------  ------  ------  ------  ------  ---  ---

Powerstack-1          SP-PSS  Ring     700     271     446     -17     2    2

Power stack name: Powerstack-1

    Stack mode: Power sharing strict

    Stack topology: Ring

    Switch 1:

        Power budget: 223

        Power allocated: 223

        Low port priority value: 21

        High port priority value: 12

        Switch priority value: 3

        Port 1 status: Connected

        Port 2 status: Connected

        Neighbor on port 1: Switch 2 - c471.fe52.1500

        Neighbor on port 2: Switch 2 - c471.fe52.1500

    Switch 2:

        Power budget: 206

        Power allocated: 223

        Low port priority value: 22

        High port priority value: 13

        Switch priority value: 4

        Port 1 status: Connected

        Port 2 status: Connected

        Neighbor on port 1: Switch 1 - 588d.09d0.0080

        Neighbor on port 2: Switch 1 - 588d.09d0.0080

SW  PID                 Serial#     Status           Sys Pwr  PoE Pwr  Watts

---  ------------------  ----------  ---------------  -------  -------  -----

1A  C3KX-PWR-350WAC     LIT14410708 OK              Good     Good     350/0

1B  Not Present

2A  C3KX-PWR-350WAC     LIT1441070H OK              Good     Good     350/0

2B  Not Present

Can someone help?

Regards,

Paul

1 Reply 1

Leo Laohoo
Hall of Fame
Hall of Fame

Downgrade your IOS to 15.0(2)SE4 and see if the error message goes away. 

For the record, 15.0(2)SE4 is not a good IOS to be using.

Review Cisco Networking products for a $25 gift card