cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
169
Views
0
Helpful
4
Replies

Switch FW Update

mikoto06
Beginner
Beginner

Hello all. I'm trying to update the FW on to Switches I obtained from 12.2 to 15.0 since its the only one I can obtain without a contract. The switch says its an IP Base in the "Sh Ver" command however when I try to update the firmware I get an error saying "Error: system number 1 does not support the same feature set."

Is this because the current FW is a universal one rather then the IP Base that I am trying to load?

4 REPLIES 4

balaji.bandi
VIP Guru VIP Guru
VIP Guru

is this stack switch or standalone.

 

can you post output of 

show version

show switch

 

what command syntax you using to upgrade.

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

Answer can be found HERE.

 

Jitendra Kumar
Rising star
Rising star

To bypass this check, add the /allow-feature-upgrade parameter to the archive download-sw command. According to the documentation, this feature is new as of 12.2

Thanks,
Jitendra

Please ignore this thread.

The OP is "shopping for answers".  His question has already been answered in other forums.  

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: