- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-15-2015 02:53 PM - edited 03-07-2019 11:34 PM
Hi Everyone,
I need to confirm config of switch port that connects to Cisco ATA switch for fax lines.
SW1 Cisco VG 202XM
int fa0/1---------------------------------------------------------------------connects to Cisco ATA switch VG 202XM port fa0/1-------------
switchport mode access
switchport voice vlan 10
Need to confirm do we need switchport access vlan and spanning tree portfast config here?
Also should we use cross over or straight through cable for this?
Regards
Mahesh
Solved! Go to Solution.
- Labels:
-
Other Switching
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-16-2015 05:33 AM
Hi Mahesh,
Your voice vlan config looks correct. As for the crossover cable, I think you can simply use a straight through cable to connect to ATA.It was a long time ago I worked with ATAs.
HTH
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-16-2015 05:33 AM
Hi Mahesh,
Your voice vlan config looks correct. As for the crossover cable, I think you can simply use a straight through cable to connect to ATA.It was a long time ago I worked with ATAs.
HTH
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-18-2015 01:13 PM
Many thanks Reza.
Regards
Mahesh