12-20-2018 04:28 PM - edited 03-08-2019 04:52 PM
Dear all,
I think recent devices are not supported for errdisable duplex-mismatch feature right?
For example, if I check throught the following command on Cat65-SUP2T however it is not supported.
Cat65-SUP2T#sh errdisable detect
ErrDisable Reason Detection status
----------------- ----------------
udld Enabled port
Cat5500> (enable) show errdisable-timeout
ErrDisable Reason Timeout Status
------------------- --------------
bpdu-guard disable
channel-misconfig disable
duplex-mismatch enable
#######################################
I think recently most of cisco devices are not integreted such feature.
Best Regards,
Masanobu Hiyoshi
12-20-2018 04:54 PM
I believe that is CATos feature, Not i have seen in IOS.
some reference of error disable available :
12-20-2018 10:00 PM
12-24-2018 05:05 PM
Thank you but it's nothing like this.
Cat65-SUP2T#sh int status err-disabled
Cat65-SUP2T#
[Condition]
Cat65-SUP2T-G1/1(speed 100, duplex ful) ----- G0/10(speed 100, duplex half)-Cat3560G
12-24-2018 05:27 PM
12-24-2018 05:37 PM
I am sure but the LC is WS-X6848-GE-TX so the speed auto or fixed are possible.
What is the hard coded meaning? 1G Fixed LC right?
12-24-2018 05:44 PM
12-24-2018 06:22 PM
Hi, I replaced "WS-X6848-SFP" but it can not change duplex configuration as follows.
Cat65-SUP2T(config)#int g1/1
Cat65-SUP2T(config-if)#
Cat65-SUP2T(config-if)#speed ?
1000 Force 1000 Mbps operation
nonegotiate Do not negotiate speed
% Unrecognized command
Cat65-SUP2T(config-if)#duplex half
^
% Invalid input detected at '^' marker.
Cat65-SUP2T#sh run int G1/1
Building configuration...
Current configuration : 66 bytes
!
interface GigabitEthernet1/1
no ip address
no cdp enable
end
Cat65-SUP2T#sh int status err-disabled
Cat65-SUP2T#
Regards,
12-25-2018 03:22 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide