01-25-2022 02:17 AM - edited 01-25-2022 02:40 AM
Hi all
I have a WS-C2960X-24PS-IN switch, the MGMT, Stat, Speed, Stack lights blinking(Orange Color) on three-time every two seconds. Not responding to LAN Port. when trying to log through the console, a message saying boot fail is displayed.
what can I do?
Please help me to solve this issue.
Thank You
Yomal
Solved! Go to Solution.
01-25-2022 02:22 AM
Contact Cisco TAC and organize for an RMA.
01-25-2022 02:22 AM
Contact Cisco TAC and organize for an RMA.
01-25-2022 02:45 AM
Does anyone has else have a different idea than this?
01-25-2022 03:25 AM
@yomaldyw wrote:
a message saying boot fail is displayed.
Console into the switch and reboot. Post the entire boot-up process.
01-25-2022 04:55 AM
No boot-up process is displayed, this is the only message that comes in there " Boot fail".
01-25-2022 05:44 AM
If this is all that shows up in the console port, then contact Cisco TAC and organize for an RMA.
NOTE: 2960X is covered under Cisco Enhanced Limited Lifetime Hardware Warranty.
01-25-2022 09:18 PM
Kindly tell me how could I contact TAC?
These are the only ones displayed on the console.
No boot process is displayed only it displays BOOT FAILED continuously
Please Find the attached with hire
01-25-2022 09:59 PM
@yomaldyw wrote:
Kindly tell me how could I contact TAC?
01-25-2022 02:42 AM
Hope you solved on below thread :
https://community.cisco.com/t5/switching/switch-ws-c2960x-24ps-in-blinking-lights/td-p/4537996
01-25-2022 02:49 AM
Yeah, I accidentally hit accept button, Does anyone has else have a different idea than this?
01-25-2022 02:53 AM
Turn off the device, connect the console cable Do you have any console output ? if not as suggested Raise an TAC case for replacement.
01-25-2022 05:03 AM
yes, I tried turning it off and on, but nothing happpend. when I try to log through the console, a message saying "boot fail" is displayed.
01-25-2022 02:42 AM
If you have configured a new switch with a wrong IP address, or if all of the switch LEDs start blinking when you are trying to enter Express Setup mode, you can clear the configured IP address. The switch returns to the factory default settings.
01-25-2022 04:59 AM
No Dear, this is a little old. this is a configured one(Not a New Switch). suddenly something like this happened.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide