11-22-2016 07:11 AM - edited 03-08-2019 08:15 AM
Hi all,
hope somone can help and explain me the following configuration situation.
In an existing network are multiple ESX Server. All ESX Server have the same network configuration.
VMNIC3 on Switchport 1/0/33
VMNIC4 on Switchport 1/0/29
VMNIC5 on Switchport 1/0/37
There is no Portchannel configuration on Cisco Switch Catalyst WS-C3750X-48
-----
port-channel load-balance src-dst-mac
!
interface GigabitEthernet1/0/29
snmp trap mac-notification change added
!
interface GigabitEthernet1/0/33
snmp trap mac-notification change added
!
interface GigabitEthernet1/0/37
snmp trap mac-notification change added
-------
All works fine, why doesn´t need Etherchannel Trunk?
Regards Marco
Solved! Go to Solution.
11-22-2016 10:20 AM
Hi,
You don't necessarily need a Portchannel when connecting ESX servers. If the VMNICs are configure with HA and if one link fails the others take over and forward traffic. You only need a trunk if you are passing multiple vlans from ESX host to the switch if not you don't need it.
HTH
11-22-2016 10:20 AM
Hi,
You don't necessarily need a Portchannel when connecting ESX servers. If the VMNICs are configure with HA and if one link fails the others take over and forward traffic. You only need a trunk if you are passing multiple vlans from ESX host to the switch if not you don't need it.
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide