switchport port security aging static command

[carl_townshend]

hi all

does this command delete the manual mac addresses entered in the port security interface configuration mode after a certain time? so even if i saved the config, would they get deleted once the timer was up ?

cheers

[Mahesh Gohil]

Hello carl,

correct understanding. please find supported information from cisco

Switch(config-if)# switchport port-security  [ aging {static | time aging_time | type {absolute | inactivity} ]

Sets the aging time for the secure port. The static keyword enables aging for statically configured secure addresses on this port. The time aging_time keyword specifies the aging time for this port. Valid range for aging_time is from 0 to 1440 minutes. If the time is equal to 0, aging is disabled for this port. The type keyword sets the aging type as absolute or inactive. For absolute aging, all the secure addresses on this port ago out exactly after the time (minutes) specified and are removed from the secure address list. For inactive aging, the secure addresses on this port ago out only if there is no data traffic from the secure source address for the specified time period

Hope this helps

Regards

Mahesh