12-13-2012 11:59 PM - edited 03-07-2019 10:36 AM
Hi
i want to prevent to servers from talk to each others .srv-dc-1:X.X.X.X connect to SW1 on port g0/0 while srv-dc-2 :Y.Y.Y.Y connect to SW10 on port g0/0.
is it good to configure switchport protected on ports where these servers connected in order to achieve this scenario, i don't want to use acl
thanks
Ibrahim
12-14-2012 12:05 AM
This command is efficient ONLY on the Same Switch (Blocking communication between ports on the Same Switch).
In Your Case, Since there are Two different interconnected SWs, Use (Private VLans with VTPv3) Or Use (VLAN MAP ACL).
Regards,
Mohamed
12-14-2012 12:07 AM
Hi Mohamed
thanks for ur reply
Pls can you post me a sample for what you have suggested
thanks
ibrahim
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: