Temperature on Cisco Switches and Router

[saeedccie]

Hi Folks,

Can anybody confirm me i have 2960 series switches and Routers but when I'm configuring with Op Manager with Temperature traps so it couldn't working on Op Manager.

Can anybody tell me is this any issue with Op Manager products OR temp. is not supported on cisco some series switches and routers.

Regards,

Saeed

[Latchum Naidu]

Hi Saeed,

I am not an expert on the Opmanager but still the below is what I found.

This is the OID which gives Cisco temperature(.1.3.6.1.4.1.9.9.13.1.3.1.3.1). Not all catalyst devices support this.

It is inside CISCO-ENVMON-MIB. Please load that mib and check if your device is responding in mibbrowser.bat which is under /OpManager/bin

Please rate the helpfull posts.
Regards,
Naidu.