cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1051
Views
0
Helpful
1
Replies

TengigE, Huge input drops

smehrnia
Level 7
Level 7

Hi Experts,

I have a question regarding a TengigE interface. i have this interface on a CRS-1 that has three Subif. all of the sub-interfaces are working without any problems, counters show no drops n basically all good. but when i run "show int" for the top-level interface, i can see a huge amount of "Input Drops".

is that normal or should i dig for a design flaw or an issue with the interface?

Thanks guys

Hope it Helps!

Soroush.
1 Reply 1

Richard Primm
Cisco Employee
Cisco Employee

Hello,

I'm not sure as I don't work on this platform very often.  Have a look at bug CSCti75606 and see if you think this might match your symptoms.

reference:

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCti75606

HTH

Lp

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco