12-19-2008 08:36 AM - edited 03-06-2019 03:04 AM
I have a reverse telnet server (2620 with a async card and the octal cable)
I can terminal in fine but I can't get it to "kill" my session when I exit. I then have to go out and do a show line and <clear line tty 2033> This is irratiting me!!I seem to recall using a terminal server that would automatically log you out, return you to the terminal server. Any suggestions?
12-19-2008 09:07 AM
It should log out all active sessions "if" you type exit on the terminal server session.
User Access Verification
Password:
Rack9Pod1>r1
Trying R1 (10.1.1.1, 2001)... Open
Rack1R1#
Rack9Pod1>exit
(You have open connections) [confirm]
Closing: r1 !
___
Are you returning to the terminal server with CTRL+SHIFT+6?
___
Edison.
12-19-2008 09:12 AM
Jason
In addition to the suggestion from Edison to use exit, I typically use shift/CTRL/6 x to get back to the term server and then type disconnect to terminate the session to the remote.
HTH
Rick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: