cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
225
Views
0
Helpful
0
Replies
Beginner

Trunking 2 Cisco 2960's through a Nortel 5530

OK here is the scenario

I have 2 2960's one at our main office and one at a remote location. They are both connected to ISP owned Nortel 5530's at each location. The ISP has created a VLAN and assigned that Single VLAN to the port on both ends that the 2960 plugs into. So once the 2960's are plugged in at each end this creates a nice link to our remote location.

My question is...I would love to be able to be able to create a trunk connection between the 2960's. Any suggestions on how to make the 802.1q traffic pass through these Nortels? I was thinking something like this on the 2960's..But have no idea about the Nortels.

switchport mode trunk

switchport trunk encap dot1q

switchport nonegotiate

Thanks for your help!!         

CreatePlease to create content
Ask the Expert- Firepower configuration & troubleshooting