11-19-2015 05:57 PM - edited 03-08-2019 02:46 AM
Dear all,
I have a problem when trunking between sw 2960x 4p - 2960x 24p , i use only 2pairs : 1,2,3,6 .
with cable i trunking 2960x 4p- 2960s ttl is ok.
pls help me that problem .
Thanks all ?
11-19-2015 06:12 PM
Hi,
Can you share the running configuration for trunk ports on both switches and "show interface trunk".
Cant you use a normal cable with all pairs?
-Jay
11-19-2015 06:47 PM
Hello,
If you used fastethenet for trunk, only 2 pairs are actually used for data transmission which you mentioned.
Pins 1$2 for transfering signals and 3$6 for receiving signals. And you can use both straight and cross-over cable since switch detects and adjusts transmitter and receiver.
Hope it helps,
Masoud
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: