I tried to make two rows to port range forwarding in my RVS4000 like this:
start 3060 end 3061 protocol Both xxx.xxx.xxx.90
start 3060 end 3061 protocol Both xxx.xxx.xxx.91
If I mark both as enabled, I'll get error message: Poliicy 0 and Policy 1 overlaps and I can not save the configuration. Exactly the same configuration works in my old Linksys. The firmware version of RVS4000 is V2.0.2.7.
Should I go back to an older version of sofware or what should I do? And if I go back to an older version, would VPN and other things work (I haven't tried yet with this)?
Thanks
