Looking for an urgent response!
I have a catalyst core switch WS-6509-NEB-A running on Version 12.2(18)SXF11. I have BGP with my carrier running on this switch. I would like to configure BFD on BGP but seems like the "fall-over bfd" option is not available under BGP section but I can do " show bfd neighbors" also able to configure bfd interval under SVI.
Since I am able to configure bfd interval and show bfd nei command just work(no output) I am assuming there is a way to configure it under BGP as well.. Can anyone pls help me how to configure If possible?
are you configuring the command under the neighbor:
neighbor x.x.x.x fall-over bfd
What if you try it under the address family ?
Thanks for replying. I tried both. Under bgp I tried " neighbor x.x.x.x fall-over bfd" didn't work, and then I tried the same command under particular address family still the switch didn't like the keyword "fall-over".
which feature set and which supervisor do you have ? Use the Feature Navigator (link attached) to find out which feature set on your sup supports BFD...