cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
445
Views
0
Helpful
4
Replies

Unable to Convert LWAPP to Autonomous AP - Cisco Aironet 1140

iphoneguru27
Level 1
Level 1

Hello all,

I am having difficulty working with my AP. I finally got access to the console port as you can see by the picture. But I cannot access the TFTP server from my AP on my PC. Any ideas? Thanks in advance!

1 Accepted Solution

Accepted Solutions

Hi, Here is a thread from yesterday, not exactly your model but have some good trouble shooting steps. Error says that it cant access the file, so make sure that you have renamed your image file (ex: - c1140-k9w7-tar.124-25d.JA.tar to be c1140-k9w7-tar.default **make sure there is no file extension presence**).Also don't forget to turn off the firewall. See how you go

***Please rate all the useful posts***
-Prabath

View solution in original post

4 Replies 4

iphoneguru27
Level 1
Level 1

I have confirmed that my computer is getting the broadcast signal from the AP, and that it is binding to 10.0.0.1. However, when I let go of the mode button, the download doesn't begin. What am I doing wrong here?

Hi, Here is a thread from yesterday, not exactly your model but have some good trouble shooting steps. Error says that it cant access the file, so make sure that you have renamed your image file (ex: - c1140-k9w7-tar.124-25d.JA.tar to be c1140-k9w7-tar.default **make sure there is no file extension presence**).Also don't forget to turn off the firewall. See how you go

***Please rate all the useful posts***
-Prabath

I finally got it to work by using linux. Thank you so much!

Hi,

Check that you have the correct ios image for access point( md5 check the file ) and you have renamed it correctly. Make sure the firewall on the PC is not stopping file transfer.

Thanks

John

**Please rate posts you find helpful**
Review Cisco Networking for a $25 gift card