I am somewhat new to IOS XE, I am working with a Catalyst 4503-E with a Sup7-E. I'm trying to enable Netflow, and I have read the following guides:
I have also enabled Netflow in IOS 12.1/12.2 and figured the process was similar (It seems to be). CEF is enabled, and I have all the pre-reqs according to the document above, however, the flow commands don't exist, they simply say "command unrecognized". Am I missing some configuration step? I have included my sh version below.
sh version (edited):
Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500e-UNIVERSAL-M), Version 03.01.01.SG RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2010 by Cisco Systems, Inc.
Compiled Tue 14-Dec-10 21:30 by prod_rel_team
Image text-base: 0x1009E914, data-base: 0x13B71550
Jawa Revision 7, Snowtrooper Revision 0x0.0x15
uptime is 7 weeks, 1 day, 23 hours, 26 minutes
System returned to ROM by power-on
Running default software
License Information for 'WS-X45-SUP7-E'
License Level: lanbase Type: Default. No valid license found.
Next reboot license Level: lanbase
cisco WS-C4503-E (MPC8572) processor (revision 8) with 786516K/16384K bytes of memory.
Processor board ID
MPC8572 CPU at 1.5GHz, Supervisor 7
Last reset from PowerUp
12 Virtual Ethernet interfaces
28 Ten Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.
Configuration register is 0x2101
Yup think you have answered your own question . You will notice it is running a universal image so probably everything is there you just have to buy the license key activation for the feature you are looking for . All the ISR's are now doing this and suspect the rest of the cisco line will follow suit in the future , myself I find it a pain in the you know what ! :-)