Dear all,
I just tried to upgrade my Cisco 2600XM router from 12.3-6 IOS to 12.4-25d IOS, but I was unable to start the router with this new IOS.
flash:c2600-ipbase-mz.123-6.bin (old IOS)
flash:/c2600-ipbasek9-mz.124-25d.bin (new IOS)
=================================================================
Output sh flash
=================================================================
System flash directory:
File Length Name/status
1 9278868 c2600-ipbase-mz.123-6.bin
2 13668524 c2600-ipbasek9-mz.124-25d.bin
[22947520 bytes used, 10082624 available, 33030144 total]
32768K bytes of processor board System flash (Read/Write)
==================================================================
Output sh version
==================================================================
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-IPBASE-M), Version 12.3(6), RELEASE SOFTWARE (fc3
)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Wed 11-Feb-04 19:24 by kellythw
Image text-base: 0x80008098, data-base: 0x80ECF624
ROM: System Bootstrap, Version 12.2(8r) [cmong 8r], RELEASE SOFTWARE (fc1)
R9_Trusted_KPN uptime is 1 hour, 9 minutes
System returned to ROM by reload
System image file is "flash:c2600-ipbase-mz.123-6.bin"
cisco 2611XM (MPC860P) processor (revision 0x300) with 94208K/4096K bytes of mem
ory.
Processor board ID JAE08138H00 (3270948457)
M860 processor: part number 5, mask 2
Bridging software.
X.25 software, Version 3.0.0.
2 FastEthernet/IEEE 802.3 interface(s)
32K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
==========================================================================
I configured the boot settings using the following command;
boot system flash:/c2600-ipbasek9-mz.124-25d.bin
Maybe there is something i forget, usually an upgrade works like this, right?
Anyone any comments please?
Thanks in advance,
ps; very strange is also the fact that i couldn't configure the ip address 192.168.30.6/29 (255.255.255.248), but it is subnetted correctly. Looks like the router doesn't support VLSM, or something like that. Any support would be very helpfull.
Wim
