cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2388
Views
0
Helpful
6
Replies
Highlighted
Beginner

Unsupported Baud settings on a 2960

I seem to have managed to set a 2960 to 230400 baud in the boot loader. Is there anyway to reset the variables in the boot loader? Maybe a set of pins to short? I can't access the console port reguardless of what I set the rate too. I've tried both the USB console cable and a USB to serial. Is there anything I can do short of an RMA?

Everyone's tags (4)
6 REPLIES 6
Highlighted
Frequent Contributor

Unsupported Baud settings on a 2960

It is little tricky, you can use aux port with xmodem commands and configure speed for the baud rate you need on line con 0 from there.....

---

Posted by WebUser Neeraj Jagga from Cisco Support Community App

Highlighted
Beginner

Unsupported Baud settings on a 2960

To my knowledge the 2960 doesn't have an AUX port. Great ideal though. I've got a usb console port, serial console, management and the USB port.

Highlighted
Hall of Fame Community Legend

Unsupported Baud settings on a 2960

Can you telnet/SSH into the appliance?

Highlighted
Cisco Employee

Unsupported Baud settings on a 2960

Andrew,

You may have to do a password recovery procedure on this switch. See link below. This should bypass your startup config so you can set to your normal 9600 and get into the switch. Hope this helps.

http://www.cisco.com/en/US/products/hw/switches/ps628/products_password_recovery09186a0080094184.shtml

Ryan

Highlighted
Beginner

Re: Unsupported Baud settings on a 2960

after command

set BAUD 23400

console speed set to ~17000 !

BUG

https://supportforums.cisco.com/thread/2238189?tstart=0

Highlighted
Beginner

Re: Unsupported Baud settings on a 2960

Hi,
Kindly help me same problem iam having C2960S.
Content for Community-Ad