cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1279
Views
0
Helpful
4
Replies

Unsupported modulo on 4510+E

Hello,

I'm implementing a pair of 4510+E switch core, but I'm having a problem. There is a kind of module that the chassis is not recognizing (Unsupported module).

 

Each chassi has:

02x 8-E supervisor

02x WS-X4748-RJ45-E

02x WS-X4712-SFP-E

02x WS-X4748-12X48U+E

 

So I updated the last version of IOS. I just did not install the IPBASE license.

 

Anyone have any idea what it might be? Is there a software version restriction or something like this?

 

Switch#sh module all

Chassis Type : WS-C4510R+E

 

Power consumed by backplane : 40 Watts

 

Mod Ports Card Type                              Model              Serial No.

---+-----+--------------------------------------+------------------+-----------

 

 7     0  Unsupported module                     WS-X4748-12X48U+E

 8     0  Unsupported module                     WS-X4748-12X48U+E

 

 

Mod  Redundancy role     Operating mode      Redundancy status

----+-------------------+-------------------+----------------------------------

 5   Active Supervisor   RPR                 Active

 6   Standby Supervisor  RPR                 Standby cold

 

Tks..!!!

1 ACCEPTED SOLUTION

Accepted Solutions

The uplink needs to be 40 Gbps or the line card will not work.

View solution in original post

4 REPLIES 4
Leo L
VIP Community Legend

What is the speed of the uplink?  It has to be 40 Gbps or it won't work. 

Go HERE and it explicitely states: 

 

  • Supported in the Catalyst 4503-E, Catalyst 4506-E, Catalyst 4507R+E, and Catalyst 4510R+E switch chassis.
  • Supported only with Supervisor Engine 7-E, Supervisor Engine 8-E, Supervisor Engine 7L-E.
  • Not supported in slot 10 in the Cisco Catalyst 4510R-E switch chassis with Supervisor Engine 8-E, when the uplink mode is 80GB, and is supported only when uplink mode is set to 40GB.
  • Can be installed on any non-supervisor chassis slot.

The uplink is 20G, by one SFP-10G-SR-S in each supervisor.
So, will l need one more SFP+ in each module?

 

@Leo L

One more question. Can I get to do these uplnk witch 4 twinax SFP+?

 

tks

The uplink needs to be 40 Gbps or the line card will not work.

Cool. Glad to hear it's working.
Thanks for taking the time to rate our posts. ☺ ✌