Hi,
I upgraded our switch 6506-E (SUP720 10G) to the last version 15.1.1 with success:
Mod Ports Card Type Model
--- ----- -------------------------------------- ------------------ -----------
1 48 CEF720 48 port 10/100/1000mb Ethernet WS-X6748-GE-TX
3 16 CEF720 16 port 10GE WS-X6716-10GE
5 5 Supervisor Engine 720 10GE (Active) VS-S720-10G
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
1 0016.c810.80ec to 0016.c810.811b 2.3 12.2(18r)S1 15.1(1)SY Ok
3 001d.4577.d038 to 001d.4577.d047 1.0 12.2(18r)S1 15.1(1)SY Ok
5 0023.33ab.7cd0 to 0023.33ab.7cd7 3.1 8.5(3) 15.1(1)SY Ok
Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
1 Centralized Forwarding Card WS-F6700-CFC xxxxxxxx 2.0 Ok
3 Distributed Forwarding Card WS-F6700-DFC3C xxxxxxxxxxE 1.0 Ok
5 Policy Feature Card 3 VS-F6K-PFC3C xxxxxxxxxxxx 1.0 Ok
5 MSFC3 Daughterboard VS-F6K-MSFC3 xxxxxxxxxxx 2.0 Ok
Mod Online Diag Status
---- -------------------
1 Pass
3 Pass
5 Pass
But sometimes, the switch sent a snmp trap error from the module WS-X6716-10GE (16 ports 10GE) and PFC card like this:
Cisco Module Status Change status 4 (okButDiagFailed)
What does this message mean? I have a problem with the module diagnostics ? A bug ?
Thanks a lot for your help
Best regards
Sam
