06-15-2016 12:42 AM - edited 03-08-2019 06:12 AM
Hello,
I need to upgrade my CISCO switch IOS but I have no Available space in the flash for the 2 IOS. can I delete the available IOS and in the same session I downloaded the new IOS or the switch will crach
my cisco switch is 3560-48PS
06-15-2016 12:55 AM
Post the complete output to the command "dir".
What IOS version & what feature set are you trying to upgrade to?
06-15-2016 02:19 AM
Dear Leo,
the below is the dir
Switch#dir
Directory of flash:/
2 -rwx 5 Mar 1 1993 09:13:45 +00:00 private-config.text
3 -rwx 1036 Mar 1 1993 01:43:42 +00:00 vlan.dat
4 -rwx 9314 Dec 24 1993 07:19:13 +00:00 config.old
5 drwx 192 Mar 1 1993 00:09:08 +00:00 c3560-ipbase-mz.122-35.SE5
463 -rwx 5858 Mar 1 1993 09:13:45 +00:00 config.text
15998976 bytes total (6928384 bytes free)
Switch#
I need to upgrade the IOS to
to Support the service policy so to be able to rate limit a special interface'
06-15-2016 02:27 AM
Ok, use this command: archive download-sw /over tftp://<TFTP IP address>/IOS_filename.tar
Remember, use the IOS file with the TAR file extension.
01-16-2017 01:56 AM
Leo I'm in the same situation with a 3550. My question is if i load the K9 ios does it require me to enter a license key ?
regards Troy
01-16-2017 11:49 AM
normally there is no special requirements needed to download a K9 file .
01-16-2017 12:50 PM
As what Glen (below) stated, no special requirement needed. You can upgrade to K9.
06-15-2016 12:58 AM
If this is a newer Cisco 3650 then;
You should be able to do a "software install file ..." and install it that way. It should cleanup and remove any files to create enough space for the installation.
I often put the new software on a usb memory key, plug it into the switch, and install it from there.
If this is an older 3560 switch, use the "archive download-sw ..." command with a full install bundle. It will remove the old software as needed.
06-15-2016 02:23 AM
Dear Philip,
how i can use the archive download-sw command. as i need to upgrade
from
to
and the only available memory is (6928384 bytes free)
06-15-2016 02:44 AM
The archive command should remove the old software for you.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: