Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
3942
Views
0
Helpful
1
Replies

UPnP in Cisco switched infrastructure

Thorsten997
Level 1
Level 1

‎08-27-2011 12:27 AM - edited ‎03-07-2019 01:55 AM

There are UPnP servers and UPnP clients in the network. Servers are connected to Cat6509, clients are connected to Cat3560 and there is connectivity between these switches. At the moment there is no UPnP connectivity between clients and servers. What is needed to do on switches to support UPnP?

Labels:
0 Helpful
1 Reply 1

Florin Barhala
Level 6
Level 6

‎08-27-2011 07:23 AM

UPnP runs at Layer 4 or above; all you need is full Layer 2 connectivity (allow same vlan span from servers to clients), then at layer 3 clients need IP addresses from servers so you have to configure DHCP relay on the right interface.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card