cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
782
Views
2
Helpful
2
Replies

VACL on switch WS-C3750X-24T-L

amolak_cisco
Level 1
Level 1

Hello,

I am trying to configure VACL capture on switch WS-C3750X-24T-L (IOS Code – c3750e-universalk9-mz.150-1.SE2.bin).

ip access-list extended IDS

permit ip any any

!

vlan access-map IDS-map

action forward capture                                   <<< not available

match ip address IDS

vlan filter IDS-map vlan-list 100

!

interface Gi1/0/3

description IDS-Monitor-Port

            switchport capture                                        <<< not available

            switchport capture allowed vlan 100            <<< not available

Please advice if this is a IOS code issue or these commands are not at all supported on this switch model.

Thanks in advance.

Regards,

Amolak

1 Accepted Solution

Accepted Solutions

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

The switch port capture commands are not available on the 3750 series switches.

HTH

View solution in original post

2 Replies 2

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

The switch port capture commands are not available on the 3750 series switches.

HTH

Thanks Reza. I got the reply from Cisco as well - "The VACL capture concept is unique to the 6500/7600 architecture hardware ASICs.   For a 3750x,  you have to use the monitor session/Local SPAN type configuration for packet mirroring."

Review Cisco Networking for a $25 gift card