cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
554
Views
0
Helpful
4
Replies

VACL support on 3560E

Curtis Griffin
Level 1
Level 1

Configuration option for 'vlan access-map' and 'vlan filter' are not available, though Feature Navigator says VACL is supported by the platform and release. 

Switch Ports Model              SW Version            SW Image                

------ ----- -----              ----------            ----------              

*    1 30    WS-C3560X-24       12.2(55)SE3           C3560E-UNIVERSALK9-M    

sw1(config)#vlan ?

  WORD      ISL VLAN IDs 1-4094

  dot1q     dot1q parameters

  group     Create a vlan group

  internal  internal VLAN

sw1(config)#^Z

Am I missing something?

1 Accepted Solution

Accepted Solutions

Your license level is lanbase and not ipbase.

These command would be supported if you had ip base license.

License Level: lanbase

License Type: Permanent

Next reload license Level: lanbase

HTH

View solution in original post

4 Replies 4

Reza Sharifi
Hall of Fame
Hall of Fame

This may be a license issue. What is your license level?

Can you post the output of "sh ver" and "sh lice"

Switch(config)#vlan ?

  WORD        ISL VLAN IDs 1-4094

access-map  Create vlan access-map or enter vlan access-map command mode

  dot1q       dot1q parameters

filter      Apply a VLAN Map

  group       Create a vlan group

  internal    internal VLAN

Switch(config)#vlan

HTH

Wondered that - but didn't see anything in the feature navigator to indicate it.  Running 'ipbase'

sw1#sh lic

Index 1 Feature: ipservices    

        Period left: 8  weeks 4  days

        License Type: Evaluation

        License State: Active, Not in Use, EULA not accepted

        License Priority: None

        License Count: Non-Counted

Index 2 Feature: ipbase        

        Period left: 0  minute  0  second 

Index 3 Feature: lanbase       

        Period left: Life time

        License Type: Permanent

        License State: Active, In Use

        License Priority: Medium

        License Count: Non-Counted

...

License Level: lanbase

License Type: Permanent

Next reload license Level: lanbase

...

Your license level is lanbase and not ipbase.

These command would be supported if you had ip base license.

License Level: lanbase

License Type: Permanent

Next reload license Level: lanbase

HTH

Joy.  thanks for the quick response.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card